Part Numbers
586869
Injector Set (Tag Numbers):
5006635
BRP periodically updates service part numbers while maintaining compatibility within the same E-TEC engine management system.
Description
OEM Evinrude E-TEC EMM (Engine Management Module) with injector set for small-block E-TEC outboards.
This system controls fuel injection, ignition timing, and engine management functions.
The unit has been tested with a CDI diagnostic tester and the CDI report will be included with your order.
This EMM shows 519 hours 57 minutes of total engine run time with no active fault codes.
Condition
- Tested with CDI diagnostic tester
- 519 hours 57 minutes run time
- One plastic mounting tab on the EMM is broken
- Other mounting tab is intact
- Small chip in epoxy near ECU mount
- This does not affect the performance or operation of the unit
- Care should be taken during installation due to the broken mount
- Minor cosmetic signs of previous use
- Ready to install
Fitment
Evinrude E-TEC Outboards
2009 & Up — 15 HP / 25 HP / 30 HP
2-Cylinder — 2-Stroke — E-TEC
Removed from:
Model: E15HPSLITS
We have provided this cross-reference with the resources we have available in regards to fitment. This most likely will not fit every model for the years and horsepowers listed. Please verify compatibility by matching the part number required for your engine.
If you need help confirming compatibility, please contact us prior to purchasing and we will be happy to assist.
Warranty
This part is sold with a 1 YEAR WARRANTY provided by Southcentral Outboards.
If the part does not work or stops working within 1 year, we will replace it. If a replacement is not available, we will issue a refund.
Disclaimer
If you order this incorrectly or change your mind within 45 days, you may return it with a 20% restocking fee plus shipping. You must contact us in order to facilitate that. You cannot open a return on eBay in this case.
